 |
I retrived info from the manufacture for finish usage and storage!
Storage directions:
All HOT STUFF™ glues have extremely good shelf lives.
See how shelf lives vary depending on bottle quantity as follows:
------------------- at Room Temperature -------------------
| 1/4 oz |
6 months |
| 1/2 oz |
9 months |
| 1 oz |
11 months |
| 2 oz |
Over 1 year |
| 1/4 lb |
Over a year |
LONG TERM STORAGE:
Place new, UNOPENED bottles in the freezer at or below 32ƒ to DOUBLE shelf life. Store used bottles at room temperature. This is because used bottles contain air from your workroom and that air contains moisture which condenses to water reducing shelf life. Always keep bottles upright when not in use. NCF-M™, NCF™ need no special storage except to avoid high temperatures
(Store below 80ƒ and keep original cap tightly screwed on).
|
PRICE IS:
$2.75 for 1-3 bottles
$2.50 4-11 bottles
$2.40 for 12+ bottles
|
Wood Surface finishing
Set the unfinished piece horizontally and wipe off all wood dust. Vacuuming is best. Apply UFO™ Thin or HOT STUFF™ to a small area and, using a business card, move the liquid around to cover as much area as possible. Repeat until the surface has been coated.
Once the whole surface is coated, instant curing is done by misting on a light spray of NCF™-Mild accelerator. Best results are achieved by holding the NCF-Mild™ bottle about three feet above the work and spraying lightly. Care should be taken not to hold the bottle over the work. This is to prevent a drip from falling onto the curing UFO™ Thin or HOT STUFF™ and causing a foaming effect. Let stand for a minute, then repeat this curing procedure to make sure all is cured. Test the area to make sure itâs all cured, by lightly passing your hand over the work.
Block sand with 320 grit 3M "Tri-Mite" silicon carbide paper. Do not wet sand. Keeping the work dry is essential.
After wiping off and vacuuming all dust, repeat the whole procedure once or twice more to achieve the depth you desire. Finer, 400 to 600 grit paper can be used now between coats. Usually two coats is enough for a beautiful finish.
When all applications and sanding have been done, check carefully to see if any areas have been sanded through the UFO™ Thin or HOT STUFF™, to the wood. If so, touch up the raw area and blend in. Take care not to sand through the UFO™ Thin. Rub with fine steel wool to a satin luster. Follow with polish and wax for a high gloss finish, if desired.
|